Date: 28-03-24  Time: 14:32 pm

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bigandyuk1

Pages: [1]
1
Fazer 1000/FZ1 corner / Re: Rev Counter 0 to 3k
« on: 15 January 2013, 01:24:26 pm »
 :D  Header pipes and exup valve replaced, TPS replaced. Now thats better, no lurching just smooth power and acceleration.

2
For Sale & Wanted / Re: Breaking fzs 1000
« on: 10 January 2013, 09:06:38 am »
TPS arrived safely. Thanks
 
Regards
Andy B :D

3
Fazer 1000/FZ1 corner / Re: Rev Counter 0 to 3k
« on: 03 January 2013, 04:08:50 pm »
Pipes are off and waiting for me to take to an engineer, also managed to buy another set which are good and will go back on tomorrow £100 for second hand set  :)  The piece on the back of the pipes was broken off so needed welding anyway.
 
Thanks for all the advice.

4
For Sale & Wanted / Re: Breaking fzs 1000
« on: 31 December 2012, 08:21:47 pm »
I am interested in the downpipes and EXUP?

5
Fazer 1000/FZ1 corner / Re: Exup system
« on: 31 December 2012, 08:15:25 pm »
I am in exactly the same position  :'( I removed the cover from the exup to find a completely seized valve (which has been damaged beyond repair and to top it off the bolts have all sheared. I priced up new and it came in at £1193.71 for the pipes and another £500 ish for the valve. I to have looked at the non EXUP downpipes on ebay at £220ish and wonder if this is the only affordable way around...... I have had the bike just over a week and feel the fault was known about when I was sold the bike. Wish I had been on here and looked up the EXUP problems.  :b

6
Fazer 1000/FZ1 corner / Re: Rev Counter 0 to 3k
« on: 31 December 2012, 11:00:27 am »
Motherf****r..... I removed the exup cover (which came off extremely easily!) the pulley has been removed and presumably binned, the valve was seized and the with the greatest will in the world I still managed to shear off all three bolts *!*&%$!£*** :'(

7
Fazer 1000/FZ1 corner / Re: Rev Counter 0 to 3k
« on: 28 December 2012, 01:17:01 pm »
Thanks, I will take a look whilst I am servicing it tomorrow.

8
Fazer 1000/FZ1 corner / Rev Counter 0 to 3k
« on: 28 December 2012, 10:26:49 am »
Hi, I am new to the forum and new to my gen 1 fazer. I have owned the bike for just over a week. I purchased it privately and rode it 50 miles home without issue. When I rode it to work on day two of my ownership it seemed to be hessitating below 3000rpm but if i gave it a handful of throttle it would pull hard with no problems. I have bought a service kit and intened to go through it this weekend. This morning on the way to work the rev counter suddenly dropped to 0 and then went up to 3k where it stayed for a couple of seconds and then returned to normal. After this had happened the bike was very smooth with no hessitation!!!! then the hessatation returned and a few miles later everything repeated itself (smoothing out again after the faukt had been shown). Ant thoughts greatly appreciated. :eek

Pages: [1]