1
For Sale & Wanted / Wanted
« on: 07 April 2018, 12:53:28 pm »
Wanted. Alternator case for Gen 1 FZS1000 paint in good condition (Silver)
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1] 2
1
For Sale & Wanted / Wanted« on: 07 April 2018, 12:53:28 pm »
Wanted. Alternator case for Gen 1 FZS1000 paint in good condition (Silver)
2
Fazer 1000/FZ1 corner / Top yoke« on: 03 March 2018, 06:30:42 pm »Am I right in thinking (poor memory, and its too cold to go out and check) the top yoke nut is M22 x1mm Des 3
For Sale & Wanted / Ivans slip on kit« on: 11 September 2017, 04:32:02 pm »
SOLD SOLD SOLD
On ebay http://www.ebay.co.uk/itm/132323428320?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649 Ivans slip on kit. Fzr1000 gen1 Drill bits unused Removed from my bike by Mike Greatorex while going Full Monty. 4
Fazer 1000/FZ1 corner / forks« on: 20 August 2017, 07:31:58 pm »
Whats the most I can drop yokes? Ive gone 12mm so far and would like to try a bit more. Fitting adjustable dog bones next week but until then will do it on the front.
5
Fazer 1000/FZ1 corner / Forum« on: 19 August 2017, 03:50:21 pm »
Any one on here a member of FZ1.Forum.com help needed.
6
For Sale & Wanted / Relay« on: 17 August 2017, 07:40:45 pm »Wanted for Gen 1 1000 Anyone have a Starting Circuit Cut Off Relay. Part number is 5EB-81950-20. Sometimes called Fuel Pump Relay. Large relay under (NS) left hand side panel No longer needed thanks 7
Fazer 1000/FZ1 corner / Interlock« on: 15 August 2017, 05:54:49 pm »Who's good on electrics. Bike interlock system Side stand problem Ive had since I brought the bike. The side stand switch has been disconnected and wire to loom bridged. If I reconnect the side stand electrics I get the following. Side stand down in Neutral wont start With clutch in, in neutral it starts Put into gear it cuts out. Side stand up runs and goes into gear So clutch switch works Gear selector switch works Side stand switch works Bike did have alarm fitted which last owner had removed and wires left disconnected as in pic they are labeled but cant see too clearly and don't want to disturb just yet but will sort out tomorrow with heat shrink. 8
For Sale & Wanted / Wanted« on: 20 April 2017, 04:28:34 pm »Wanted Exup cable bracket FZS1000 gen 1 9
For Sale & Wanted / wanted« on: 11 April 2017, 04:04:37 pm »Wanted Exup pulley wheel FZS1000 gen1 2002 2001 > 2005 will fit 10
Fazer 1000/FZ1 corner / Carbs« on: 31 March 2017, 05:43:17 pm »Did the carbs remain the same on all Gen 1 1000's UK spec 12
Fazer 1000/FZ1 corner / dog bones« on: 20 March 2017, 09:08:14 am »Hi Can anyone give me the sizes of the bolts that go through the dog bones. I don't want to remove to measure. Need length of unthreaded and total length as in pic, from inside of bolt head. I have new adjustable dog bones that are wider than originals and so will need longer bolts to fit. 13
Fazer 1000/FZ1 corner / Indicators« on: 15 March 2017, 04:46:01 pm »Want to change my indicators to mini type (not the car) led? what fits, any links please. Don't want to pay for solid gold type either gen1 2002 fzs1000 Des 14
For Sale & Wanted / Wanted« on: 12 March 2017, 07:22:22 pm »fzs1000 Gen 1 Wanted, under tray to cut down for tail tidy PM me please. Des 15
Fazer 1000/FZ1 corner / Fuel cap« on: 18 February 2017, 10:53:59 am »Anyone fitted a cheap fuel cap from China http://www.ebay.co.uk/itm/Billet-Gas-Fuel-Tank-Cap-Cover-for-Yamaha-FZ1-FZ6-FZR750-FZR1000-All-Years-Black-/121830592124?hash=item1c5dab4e7c:g:RLEAAOSwfZ1WX7XJ 16
Fazer 1000/FZ1 corner / Bar end weights« on: 27 September 2016, 02:15:04 pm »
Nothing to do with me, just spotted while browsing Ebay
These do look nice I have them on mine and have weight for vibration. http://www.ebay.co.uk/itm/Motorcycle-R-G-Bar-End-Sliders-for-YZF600-750-1000-TDM-Fazer1000-FZR600-1000-/162215923014?hash=item25c4d28d46:g:j0EAAOSwPCVX5pKN 17
Fazer 1000/FZ1 corner / iridium screen« on: 18 September 2016, 05:59:59 pm »
I'm after an Iridium screen like blue one below
I know they change colour with the light etc but is the gold one the same just different light ???? 18
Fazer 1000/FZ1 corner / Mirrors« on: 15 September 2016, 05:09:33 pm »
Well after a lot of reading and pondering I ordered the mirrors.
Mirrors from ebay. http://www.ebay.co.uk/itm/231893553453?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT I had to cut 3mm off the throttle slide and the rolled edge off the grips so I could fit onto the R & G bar ends so as not to spoil look. Very pleased with result and I can now see without moving my elbows out of the way. Went with the mirrors with the extra adjusting knuckle. I have ordered cheap mirror block off plates from china (If no good only a few pounds) http://www.ebay.co.uk/itm/291532049617?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT But until they arrive cut out some carbon look vinyl which doesn't look too bad. 19
Fazer 1000/FZ1 corner / Mirror blank plates« on: 11 September 2016, 10:46:10 am »
Before I order some mirror blanking plates from China can someone confirm that the R1 2000-2006 will fit an FZS1000 2002
From what I have read R1 & R6 will fit from same year Don't want to spend stupid money on them and have trouble finding some Should get them in time to wrap up for winter :-( http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=302068902419#ht_4740wt_1217 20
Fazer 1000/FZ1 corner / White dials« on: 22 August 2016, 02:14:23 pm »
Decided to go white as its not easy to read at a quick glance with the black.
Also changed bulbs to led's while I was at it. Not everyone will like them but I do Des 21
Fazer 1000/FZ1 corner / fuel« on: 21 August 2016, 08:47:42 am »
When does the fuel light come on, on your bike
Mine doesn't come on until the needle is just past the empty mark. 22
Fazer 1000/FZ1 corner / Brake pads again« on: 14 August 2016, 01:10:37 pm »
Where is the cheapest place to get oem front pads from ?
23
Fazer 1000/FZ1 corner / end can« on: 02 August 2016, 02:50:14 pm »
Ive searched and cant find answer
Will end can from gen11 fit gen1 not worried about mounting bracket Des 24
For Sale & Wanted / Heated grips« on: 30 July 2016, 07:28:15 pm »
Guaranteed working.
Plug and play http://www.ebay.co.uk/itm/Motorcycle-heated-grips-/131894036472?ssPageName=ADME:L:LCA:GB:1123 25
Fazer 1000/FZ1 corner / Givi« on: 27 July 2016, 02:37:42 pm »
What's it worth? Give
Came on bike, been painted All bolts etc and plate
Pages: [1] 2
|