This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - red imp
1
« on: 28 January 2015, 01:52:40 am »
Thank you , I have now changed the bar ends.
2
« on: 26 January 2015, 06:43:11 pm »
Does anyone know what size Allen key I need to remove my bar ends on 2010 fz1 ? And is it a straight case of undoing the old and screwing the new ones in ?
Regards
Ian
3
« on: 14 January 2015, 08:18:44 pm »
Battery is almost new, everything else runs ok , ie: indicators ,break lights and headlights.
4
« on: 14 January 2015, 06:36:09 pm »
this morning on the way to work I noticed my dials were not displaying(2010 fz1s) intermittently the whole dash would come to life with the rev counter and display showing as they would on start up but then going off again. The only thing different I have done to the bike lately was wash it last Thursday. does anyone have any idea of what the problem might be or how to get the displays working again? Thank You.
5
« on: 13 October 2014, 06:51:26 pm »
Know what you mean , I have no leccy in the garage either so I have purchased an optimate charger and will hooked it up from time to time for a few hours just to top the battery up.
6
« on: 13 October 2014, 04:13:16 pm »
I put a new battery on it today and it started first turn !
7
« on: 12 October 2014, 10:58:21 am »
Thanks for the advice , I will give it a go . The bike is garaged overnight. The dealer I bought the bike off suggests I crank the throttle open to send a message to the ecu to release extra fuel?
8
« on: 11 October 2014, 08:44:14 pm »
Hi
I started the bike up this morning and the engine turned over fine on the button but would not fire up, I have had the bike seven months and it has not missed a beat until now. I am totally baffled at why this has happened this morning. I changed the end can to a Leo vince a couple of months ago but as I said the bike has not missed a beat until now. Has anyone had the same problem or knows what the problem could be? Fazer FZ1 on a 2010 plate.
9
« on: 06 September 2014, 03:36:26 pm »
Enjoy.
10
« on: 06 September 2014, 03:34:44 pm »
Thanks devilsyam , I will. 
11
« on: 06 September 2014, 11:05:55 am »
Hi All
I have recently fitted a Leo Vince end can, I have read on the good old internet that I should also fit a power commander or risk the engine blowing !! have any of you good folk experienced or know if this is so?? The end can does pop a little and the fuel consumption has improved since the end can was fitted.
12
« on: 01 September 2014, 07:43:40 pm »
Thank for the advice. Upwards on onwards it is then. 
13
« on: 01 September 2014, 05:06:54 pm »
I have just noticed that the previous owner has had the back tyre plugged after i assume was a puncture. is it safe to ride or would it be best to replace the tyre? I have done a few miles on it since i bought the bike.
14
« on: 01 September 2014, 12:33:54 pm »
I just had a leo vince sbk fitted , it looks cool but is really close to the swing arm and actually touches the swing arm when parked up on side stand. I am sure it will be ok. unless anyone knows how i can get it further away from the swing arm .
15
« on: 12 August 2014, 08:37:40 pm »
What is this ivonising people are always talking about? and How can I get ivonised?
16
« on: 12 August 2014, 08:31:11 pm »
Road smart 3 are good
17
« on: 12 August 2014, 08:30:13 pm »
Hi All
I am looking for an after market end can for my 10 reg fazer fz1s, I really can not afford an Akropovic so I was wondering if anyone has any good advice? I am currently looking at an entry level Leo Vince sbk.
Regards
Ian
18
« on: 06 August 2014, 08:52:09 pm »
Renthal advised me to fit 7541 bars but my mechanic suggested fatbar , I am after a raised handlebar position instead of flat. are your bars higher and do you have any photo's of the Renthal bars please.
19
« on: 30 April 2014, 05:36:26 pm »
2010 FZ1
20
« on: 28 April 2014, 01:24:08 pm »
How accurate is the led fuel gage on the fz1s gen 2 fazer? Mine drops to two bars within sixty to seventy miles.
21
« on: 27 April 2014, 09:27:10 pm »
My blue FZ1S
22
« on: 27 April 2014, 09:24:22 pm »
I would be interested if it was road legal . Thanks.
23
« on: 26 April 2014, 01:30:16 pm »
Left it in the garage because it was peeing down with rain when I left for work 
24
« on: 26 April 2014, 01:23:42 pm »
Got me ipod on in the background to get me through my twelve hour shift so everything from the strypes to candi staton , playing at the moment is Jefferson airplane's white rabbit .
25
« on: 26 April 2014, 11:44:33 am »
I work for the national blood service , supplying blood products to all hospitals In East Anglia and hospitals beyond East Anglia when required.
Are you a Blood Runner? I know some of them down here in the Hampshire area.
No I am not a blood runner , I work 24/7 shifts for the National Blood Issuing Department in Cambridge. Still being shafted behind closed doors by this government but like many of my colleagues still dedicated to getting the blood to the patient ASAP. Hopefully we will not ever need it but if we do we will do our upmost to get it to everyone quickly.
PS They may also have carried the blood for Zippywight's daughter 
|
Show Posts
