Date: 28-03-24  Time: 10:27 am

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - paul1962

Pages: [1]
1
General / printed mugs
« on: 15 December 2016, 11:30:53 am »
Not sure if this will be allowed but on my face book page pepe.prints I have put togeather a mug design for various coloured mugs
just wonderd if anyone would like a look if so please check out pepe.prints on Facebook,

will try a put a pic on here
fazer mug lh red
fazer mug lh red

2
FZS600 Fazer / Out for a ride
« on: 13 November 2016, 10:03:19 am »
Just got kitted up and ready for a ride maybe to the  ponderosa, maybe delemere, will see, so see you out there guys

Paul

3
FZS600 Fazer / Helmet cam
« on: 12 November 2016, 10:42:32 am »
Does any one on here recomend a helmet cam and if so , how much and where from and how do they fit etc, as I am looking to getting one for future trips on the Fazer and even the bike with no engine just pedals ............................................!!!!


thanks guys

Paul

4
FZS600 Fazer / New screen fitting
« on: 08 November 2016, 06:39:45 pm »
I have bought an after market dark screen fo rmy 03 Fazer and I just wondered is it hard to fit and is there an how to ? to fit it or is it a simple job to do
to remove the old one and fit  the new one

thanks  again guys

Paul

5
FZS600 Fazer / Spark plugs
« on: 06 November 2016, 11:33:29 am »
Now forgive this question but never had a Fazer before my last bike was a Blackbird, but do you need to remove the tank on the fazer to get the plugs out to check them

and /or change the air filter

still waiting for my Haynes to come in the post

Thanks guys

Paul

6
FZS600 Fazer / Carb balancing
« on: 04 November 2016, 07:01:05 pm »
Just a quickie on how much would it be to have my carbs balanced, or for a kit to do the job myself ?have tried a google on this with varried results
but how much have peep on here paid to have it done, or is there someone close to Chester with a kit that could come and show me how to do it

thanks

Paul

7
General / Top end rattle
« on: 31 October 2016, 06:15:03 pm »
Not really noticed it before but went to start my 2003 Fazse 600, and when it burst into life there was a defo load ish ticking comming for the top of the engine, the bike has done 40,000 but been well looked after is this something I should be worried about only gets a bit quieter when fully warm but not completelty

thanks guys

Paul

8
General / Rear Higger
« on: 31 October 2016, 05:52:19 pm »
No sure if in the right place but, has anyone got a rear hugger knocking about anywhere, preferable in black, but as long as it can be painted then great  need one for my
2003 Fazer 600 also looking for as cheap as poss and close ish to chester  so could collect or pay postage.

thanks

Paul

9
FZS600 Fazer / Hugger
« on: 30 October 2016, 05:41:42 pm »
Anyone selling a hugger for a 03 fazer 600 got to be black

thanks

Paul :)

10
General / Down pipes
« on: 30 October 2016, 01:53:22 pm »
Hi Guys just wondered, as my Fazer has the stainless down pipe which are stained, would it be ok to Paint them black with heat resistant paint ?

as I have had no succsess in trying to clean them up

thanks guys, alos a pic of my Fazer is in my thread in the welcome section

Paul

11
Introduction / hi Guys
« on: 27 October 2016, 08:06:55 pm »
Just like to say hi guys just got myself a fazer 600 on a 03 plate, love it so far

Name is Paul from Mollington nr Chester Had a few Bird before so after a few bumps I wanted something a bit lighter so got the Fazer and so far seems a great buy

Paul  :thumbup

Pages: [1]