The mra vario screen sold, brake pads and streetfighter screen £55 posted

Sent from my Pixel 4a using Tapatalk

Mra vario..... Streetfighter screen.... Rear brake pads.... £110.... Posted

Sent from my Pixel 4a using Tapatalk

Brand new unopened £15 plus post

07842167243

Sent from my Pixel 4a using Tapatalk

For sale..... Been sitting in loft for many years.... Not new but vgc.... £60 plus post


Dave 07842167243


cheers

thanks for responding everyone, especially mike gtx......on the advice of all, i'll ride more, worry less.


cheers all

it had a air filter about 4k miles ago...... if you all think its ok , thats good enough for me...... i just expected the plugs to be a bit more on the brown side of black....... the only reason i took them out to check was because the end can exit pipe looked a bit sooty....... its running ok though, all be it a bit juicy on the mpg ....


cheers

it does not need choke to start

its about 2mA ..... ive got a motorbatt battery on mine..... not holding charge to start bike after a week or so..... old wireing  or old battery..... suppose i wil get a new battery first


cheers

doe anyone have a definitive answer to what this should be on a gen 1 with no alarm or usb port etc, ignition switched off...... the manual i saw says 1mA, but this may be a generic figure....... have searched forums for an answer to no avail






cheers

Quote from: blackcabbie on 13 April 2019, 10:39:05 pm

cant refit it cos i dont have the ais  anymore..... dont think contacting yam usa again would do any good...... does the uk coc give a nox value ??

If you need an ais i have one in the shed not doing any thing.it would need the gaskets that fit on the exhaust stubs.Malc

thanks for the offer malc..... very much appreciated......i dont use the bike currently in london, so not desperate for the exemption..... i just wanted it for future proofing so i think i'll wait and see if a block exemption of fzs1000 is likely

Quote from: b1k3rdude on 12 April 2019, 07:40:00 am

Quote from: blackcabbie on 11 April 2019, 08:37:41 pm

Mines a usa import and yamaha uk wont supply a coc  against my frame/engine number

Same here, hence having to possibly sell it. You and I have the option of taking a £175 punt of that bike shop in hackey - but I have lots of other things I can use £175 on...

Have you tried yamusa or probably Yamaha.com?

yes i contacted yamaha usa a few months ago.... they were very helpful on the phone and said they could supply a coc...great i thought... however what arrived is a letter stating bike conforms to all federal and state laws..... no mention of a nox level........obviously useless to present to tfl


i was hoping mag would get whole model range exempted, because mine shows fzs1000 on logbook not fz1


if i got it tested at that garage in hackney, it may not pass cos i have removed ais......


any thoughts on this ????

this must be a flawed system.....2 identical fazer 1000s in the ulez zone, one with a coc, the other without....... the one without the coc  gets a fine, but that must be contestable if you have an identical bike...... i think i'll wait for mag to see if they get block exemptions