Hi,


I've taken my carbs out two weeks ago to clean them prior calibration. Happy to say they were very clean, but I went over everything with carb clean anyway. Put everything together, bike starts but my throttle cables seem to be too tight/short and the twist grip is heavy to turn as well, also no slack at all.
Since then I had carbs in and out of the bike multiple times, dissasamled and put them together a few more times. For the past two weeks I just have them in my room, but still was not able to identify the cause of the problem. I double and triple checked the way I set cables in, with no luck.
I'm very desperate at this point, and will be very grateful for any advice. Miss my bike and want to get it back on the road as soon. As possible.


The list of things I've tried (with carbs on and/or off the bike):
- if cables are rooted correctly and not catching on anything while on the bike.
- cables outer housing is at the shortest setting.
- lubing old cables.
- installing new cables (same length, checked many times).
- adjustment on the carb side (shortest setting again).
- obvious damage to carbs (return springs etc).
- TPS, tried with and without it.


Throttle bodies spring back as normal.
I'll include pictures how I attached the cables on carb side and at the throttle tube.


I might have missed something, but I'm very frustrated at this point and will be thankful for any input from you guys.


Cheers,


Vlad