Bikes, Hints'n'Tips > FZS600 Fazer
cafe racer project
brooker81:
Well the donor fzs600 turned up last night.... R6 rear swingarm at the ready and a shit load of blood sweat and tears to come
Disorderlypunk:
definatly keep us updated - im thinking of going single sided swingarm on mine
but im a crazy fool who likes to jump in the deep end
lifeguards are on standby
brooker81:
--- Quote from: Disorderlypunk on 16 August 2017, 01:46:16 pm ---definatly keep us updated - im thinking of going single sided swingarm on mine
but im a crazy fool who likes to jump in the deep end
lifeguards are on standby
--- End quote ---
Cheers im sure it will be needed
brooker81:
here's roughly what i'm going for...
Carter:
Take care with your chain run, I've gone down a chain size and used a kwak front sprocket with an offset to give a bit of extra clearance from the swingarm. It gets pretty close where the nylon runner is. If it's any help I could take a few measurements from mine if you get stuck.
Edit- just saw you're looking at the later swing arm. Mine's the early model R6. 5EB I think.
Navigation
[0] Message Index
[#] Next page
Go to full version